RealView ICE reset signals

The RealView® ICE run control unit has two reset signals connected to the debug target hardware:

The target hardware must include a pull-up resistor on both reset signals. In the RealView ICE run control unit, the strong pull-up/pull-down resistance is approximately 100Ω, and the weak pull-up/pull-down resistance is approximately 4.7kΩ. Because you can select the drive strength for nTRST and nSRST, target assemblies with a variey of different reset configurations can be supported.

Show/hideSee also

Concepts
Reference

Using the Debug Hardware Configuration Utilities:

Copyright © 2010 ARM. All rights reserved.ARM DUI 0517A
Non-ConfidentialID051610