The RealView ICE User I/O connector

The User Input/Output (I/O) connector is situated on an end panel of the RealView® ICE unit. The connector is a 10-way 2.54mm pitch Insulation Displacement Connector (IDC) header that mates with IDC sockets mounted on a ribbon cable, as shown in the following figure.

Figure 12. User I/O pin connections

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


Warning

You must establish a common ground between the RealView ICE unit and the target hardware before you connect any of the User I/O signals.

The following table shows the User I/O pin connections.

Table 4. User I/O pin connections

Pin

Signal

I/O

Description

Pin 1

Output 1

Output

This is a user output bit. It operates at a 3.3V swing, with a 100Ω series resistance.

Pin 2

Output 2

Output

This is a user output bit. It operates at a 3.3V swing, with a 100Ω series resistance.

Pin 3

Output 3

Output

This is a user output bit. It operates at a 3.3V swing, with a 100Ω series resistance.

Pin 4

Output 4

Output

This is a user output bit. It operates at a 3.3V swing, with a 100Ω series resistance.

Pin 5

Output 5

Output

This is a user output bit. It operates at a 3.3V swing, with a 100Ω series resistance.

Pin 6

Input 1

Input

This is a user input bit. It has a 10kΩ weak pull-up to the unit internal +3.3V supply, and requires a Vih(min) of 2.0V and a Vil(max) of 0.8V. It can safely be driven by 5V logic levels, and has Electro Static Discharge (ESD) protection greater than the 2kV human body model.

This pin is not currently supported.

Pin 7

Output 6

Output

This is a copy of the trigger output on the end panel of the RealView ICE unit. It operates at a 3.3V swing, with a 100Ω series resistance.

Pin 8

Input 2

Input

This is a copy of the trigger input on the end panel of the RealView ICE unit. It has a 10kΩ weak pull-up to the unit internal +3.3V supply, and requires a Vih(min) of 2.0V and a Vil(max) of 0.8V. It can safely be driven by 5V logic levels, and has ESD protection greater than the 2kV human body model.

This pin is not currently supported.

Pin 9

+3.3V

Output

This is intended for powering external signal conditioning circuitry, to a maximum current of 100mA. Incorrect use of this output might cause the RealView ICE unit to enter current limit.

Pin 10

GND

-

-


Note

Input is not currently supported on the User I/O pin connections.

Show/hideSee also

Reference

Setting up the Hardware:

Copyright © 2010 ARM. All rights reserved.ARM DUI 0517A
Non-ConfidentialID051610