Dual-Mictor trace probe for RVT2

A 32-bit, dual-Mictor trace probe is available for use with RVT2 units. This probe is connected to the 40- and 60-way trace probe connectors on the RVT 2 unit using a split-ribbon cable. The following figure shows the dual-Mictor trace probe.

Figure 16. 32-bit dual-Mictor trace probe

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


Note

Support shrouds that are fitted around target connectors cannot be used with the dual-Mictor trace probe.

A typical arrangement using the dual-Mictor trace probe is shown in the following figure.

Figure 17. RVT2 unit connections

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


It is possible to use extender cables for connecting the dual-Mictor probe to the trace connector on the target board. See the following figure.

Figure 18. Dual-Mictor probe with extender cables

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


Note

If extender cables are used, for optimum results the maximum length of these must not exceed 300mm.

Note

It is not recommended that you use the extender cables for targets with a trace clock over 300MHz.

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0517D
Non-ConfidentialID071311