RVI reset signals

The RVI run control unit has two reset signals connected to the debug target hardware:

The target hardware must include a pull-up resistor on both reset signals. In the RVI unit, the strong pull-up/pull-down resistance is approximately 100Ω, and the weak pull-up/pull-down resistance is approximately 4.7kΩ. Because you can select the drive strength for nTRST and nSRST, target assemblies with a variey of different reset configurations can be supported.

Show/hideSee also

Concepts
Reference

Using the Debug Hardware Configuration Utilities:

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0517D
Non-ConfidentialID071311