4.2.3. Terminal parameters

When the MPS RTSM starts, a TCP/IP port for each enabled Terminal is opened. This is port 5000 by default, but increments by 1 until a free user port is found. For more information on using the Terminal component, see Using a terminal with a system model.

Table 4.10 lists the terminal instantiation-time parameters that you can change when you start the model. The syntax to use in a configuration file is:

terminal_x.parameter=value

where x is the terminal ID 0, 1, 2 or 3 and parameter is the parameter name.

Note

The telnet Terminal does not obey control flow signals. This means that the timing characteristics of Terminal are not the same as a standard serial port.

Table 4.10. Terminal instantiation parameters

Component nameParameterDescriptionTypeValuesDefault
terminal_[0-3]modeTerminal operation mode.stringtelnet[a], raw[b]telnet
terminal_[0-3]start_telnetEnable terminal when the system starts.booleantrue or falsetrue
terminal_[0-3]start_portPort used for the terminal when the system starts. If the specified port is not free, the port value is incremented by 1 until a free port is found.integervalid port number5000

[a] In telnet mode, the Terminal component supports a subset of the telnet protocol defined in RFC 854.

[b] In raw mode, the Terminal component does not interpret or modify the byte stream contents.


Copyright © 2011 ARM. All rights reserved.ARM DUI 0575C
Non-ConfidentialID010512