13.140 SSUB8

Signed parallel byte-wise subtraction.

Syntax

SSUB8{cond} {Rd}, Rn, Rm

where:

cond

is an optional condition code.

Rd

is the destination register.

Rm, Rn

are the general-purpose registers holding the operands.

Operation

This instruction subtracts each byte of the second operand from the corresponding byte of the first operand and writes the results into the corresponding bytes of the destination. The results are modulo 28. It sets the APSR GE flags.

Register restrictions

You cannot use PC for any operand.

You can use SP in A32 instructions but this is deprecated. You cannot use SP in T32 instructions.

GE flags

This instruction does not affect the N, Z, C, V, or Q flags.

It sets the GE flags in the APSR as follows:

GE[0]

for bits[7:0] of the result.

GE[1]

for bits[15:8] of the result.

GE[2]

for bits[23:16] of the result.

GE[3]

for bits[31:24] of the result.

It sets a GE flag to 1 to indicate that the corresponding result is greater than or equal to zero. This is equivalent to a SUBS instruction setting the N and V condition flags to the same value, so that the GE condition passes.

You can use these flags to control a following SEL instruction.

Availability

The 32-bit instruction is available in A32 and T32.

For the Armv7‑M architecture, the 32-bit T32 instruction is only available in an Arm®v7E-M implementation.

There is no 16-bit version of this instruction in T32.

Non-ConfidentialPDF file icon PDF versionDUI0801J
Copyright © 2014–2017, 2019 Arm Limited or its affiliates. All rights reserved.