|Home > Overview of AArch32 state > Register accesses in AArch32 state|
16-bit T32 instructions can access only a limited set of registers. There are also some restrictions on the use of special-purpose registers by A32 and 32-bit T32 instructions.
Most 16-bit T32 instructions can only access R0 to R7. Only a small number of T32 instructions can access R8-R12, SP, LR, and PC. Registers R0 to R7 are called Lo registers. Registers R8-R12, SP, LR, and PC are called Hi registers.
All 32-bit T32 instructions can access R0 to R12, and LR. However, apart from a few designated stack manipulation instructions, most T32 instructions cannot use SP. Except for a few specific instructions where PC is useful, most T32 instructions cannot use PC.
In A32 state, all instructions can access R0 to R12, SP, and LR, and most instructions can also access PC (R15). However, the use of the SP in an A32 instruction, in any way that is not possible in the corresponding T32 instruction, is deprecated. Explicit use of the PC in an A32 instruction is not usually useful, and except for specific instances that are useful, such use is deprecated. Implicit use of the PC, for example in branch instructions or load (literal) instructions, is never deprecated.
MRS instructions can move the
contents of a status register to a general-purpose register, where
they can be manipulated by normal data processing operations. You
can use the
MSR instruction to move the
contents of a general-purpose register to a status register.