|Home > Linker Optimization Features > Factors that influence function inlining|
There are a number of factors that influence the linker inlines functions.
The following factors influence the way functions are inlined:
The linker handles only the simplest cases and does not inline any instructions that read or write to the PC because this depends on the location of the function.
If your image contains both A32 and T32 code, functions that are called from the opposite state must be built for interworking. The linker can inline functions containing up to two 16-bit T32 instructions. However, an A32 calling function can only inline functions containing either a single 16-bit encoded T32 instruction or a 32-bit encoded T32 instruction.
The action that the linker takes depends on the size of the function being called. The following table shows the state of both the calling function and the function being called:
Table 4-1 Inlining small functions
|Calling function state||Called function state||Called function size|
|A32||A32||4 to 8 bytes|
|A32||T32||2 to 6 bytes|
|T32||T32||2 to 6 bytes|
The linker can inline in different states if there is an
equivalent instruction available. For example, if a T32 instruction is
adds r0, r0 then the linker can inline
the equivalent A32 instruction. It is not possible to inline from A32 to T32
because there is less chance of T32 equivalent to an A32 instruction.
For a function to be inlined, the last instruction of the function must be either:
MOV pc, lr
A function that consists only of a return sequence can be
inlined as a
A conditional A32 instruction can only be inlined if either:
The condition on the
BL matches the condition on the instruction being
inlined. For example,
BLEQ can only
inline an instruction with a matching condition like
or the instruction to be inlined is unconditional. An unconditional
BL can inline any conditional
or unconditional instruction that satisfies all the other criteria.
An instruction that cannot be conditionally executed cannot be
inlined if the
BL instruction is
BL that is the last
instruction of a T32 If-Then (IT) block cannot
inline a 16-bit encoded T32 instruction or a 32-bit
CPS instruction. This is because the IT block
changes the behavior of the instructions within its scope so inlining the
instruction changes the behavior of the program.