If you had not yet loaded a model at the time that Model Debugger
In the Load Model dialog box that appears, locate
and select the required model, then click Open.
A dialog box appears:
Figure 2-2 Configure Model Parameters dialog box
If you had already loaded a model before Model Debugger starts, Model Debugger checks the
available components and opens a similar dialog box.
NoteThe exact contents and titles of the panes might differ
because they depend on the model.
The Configure Model Parameters dialog box has the following sections:
This pane contains a hierarchical list of the component parameters by category.
To expand the view, click the + symbol. To
collapse the view, click the - symbol.
- Parameter setting
The parameter values are displayed in the right-hand
To toggle between hexadecimal or decimal views, use the box in the lower left
corner of the window.
NoteThe name of this pane varies, depending on the model, but its
purpose and usage is the same in all cases.
To view the configuration parameters as a single list, click the List View tab. The Tree
View is similar, but shows the same parameters in a grouped hierarchy.
Figure 2-3 Configure Model Parameters dialog box,
List View tab
Set the parameters for the model and click OK to
close the Configure Model Parameters dialog box.