ARM Technical Support Knowledge Articles

USING THE ENTER COMMAND

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I cannot get the ENTER command to work in the debugger. I am entering the following:

enter char x:0=1,2,3,4,5

and I receive the following error message:

Error 34: undefined identifier

ANSWER

Only use E for the ENTER command. For example, if you change your example to the following it will work:

e char x:0=1,2,3,4,5

Article last edited on: 2004-06-29 11:19:15

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential