ARM Technical Support Knowledge Articles

ASSEMBLER PROBLEMS IMPORTING C251 SOURCE-MODE

Applies to: uVision IDE

Answer


Information in this article applies to:


SYMPTOMS

When importing a uVision project for the C251 into uVision Version 2, assembly files are built in BINARY mode rather than SOURCE mode.

CAUSE

This problem is caused by the uVision IDE not passing the MODSRC directive to the assembler. Note that C files are compiled with MODSRC. Only the assembly files are built incorrectly.

RESOLUTION

This problem is corrected in uVision V2.11 and later.

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2005-05-19 18:45:51

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential