ARM Technical Support Knowledge Articles

TARGET AND LOCATE DIALOG RELATIONSHIP

Applies to: uVision IDE

Answer


Information in this article applies to:


QUESTION

How do the memory settings in the Target Dialog and the BL51 Linker Dialog differ?

ANSWER

In uVision, the Target dialog allows you to specify 3 ranges of CODE (ROM) memory and 3 ranges of XDATA (RAM) memory. These ranges are translated into the required CODE and XDATA options for the linker and are displayed in the BL51 Locate Dialog.

You may choose to manually control the CODE and XDATA ranges in the BL51 Locate Dialog. To do so, be sure you uncheck the Use Memory Layout from Target Dialog checkbox in the BL51 Locate Dialog.

You may only use the Target Dialog or the BL51 Locate Dialog, but not both. The Target Dialog is easier to use but it is not as flexible.

Article last edited on: 2004-06-28 10:02:54

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential