ARM Technical Support Knowledge Articles

MEMORY WINDOW ADDRESSES

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

Is there a command I can enter from the Command Window to select the memory spaces displayed in the four tabs of the Memory Window?

uVision doesn't seem to save my settings between debug sessions and I must re-enter these each time I start the debugger.

ANSWER

No. There is no command that you can type to set the contents of the memory window.

However, uVision SHOULD be saving the address specified so you should only have to enter them the first debug session. To check your debugger settings:

That should do it.

Article last edited on: 2004-06-28 11:37:28

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential