ARM Technical Support Knowledge Articles

NOT ALL INTERRUPT SOURCES APPEAR IN DIALOG

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I am using the uVision Target Debugger with MON51 with the Cypress EZ-USB devices. External Interrupt 0 and External Interrupt 1 do not display in the Interrupt Dialog under the Peripherals menu.

Is there anything I must do to view these interrupts?

ANSWER

This is a known problem in uVision V2.14 and earlier. We are working on new peripheral display DLLs for the Monitor that will include this correction. This will be available by the end of Summer 2001.

Article last edited on: 2004-06-28 19:17:32

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential