ARM Technical Support Knowledge Articles

CONNECTION TO TARGET SYSTEM LOST

Applies to: MON51 Target Monitor

Answer


Information in this article applies to:


QUESTION

I have configured the monitor for my target hardware and have successfully downloaded my program. However, when I start running the code (either by single-step or by run) I receive the following error:

CONNECTION TO TARGET SYSTEM LOST

and I must reset the hardware. What is wrong with my configuration?

ANSWER

This error message is generated when the monitor program running on the target hardware loses communication with the monitor driver running on the PC. This is typically caused by changes (in your program) to the serial UART or to the baudrate timer. Take heed of the following:

SEE ALSO

Article last edited on: 2004-06-29 14:45:25

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential