ARM Technical Support Knowledge Articles


Applies to: C51 C Compiler


Information in this article applies to:


I would like to address the low or high byte of an int variable. Is there a way to access this directly in the C language?

Other compilers offer me macro or intrinsic functions do to that. Why is there no such function in Keil C51?


The C Language allows you to directly access the low or high bytes of an int/unsigned int variable. The Keil C51 Compiler is an optimizing compiler that generates very efficient code for such constructs. Therefore, there is no need for special intrinsic functions.

Following are two solutions to your problem.

The following example uses shift operations to perform byte accesses. This is Standard ANSI C and it may be easily ported to any other microcontroller plattfrom regardless of the byte order (little endian or big endian) in the target hardware.

#define LOWBYTE(v)   ((unsigned char) (v))
#define HIGHBYTE(v)  ((unsigned char) (((unsigned int) (v)) >> 8))

unsigned int  x;
unsigned char cl, ch;

void test (void)  {
  cl = LOWBYTE(x);
  ch = HIGHBYTE(x);

The previous example only handles read accesses. If you need write accesses at the byte level, you may use the following pointer definitions. The following example is written for architectures with big endian byte order (like the 8051) and must be adjusted to run on little endian architectures.

#define BYTELOW(v)   (*(((unsigned char *) (&v) + 1)))
#define BYTEHIGH(v)  (*((unsigned char *) (&v)))

void test1 (void)  {
  BYTEHIGH (x) = 5;

Both program examples generate code that is comparable to assembler programming techniques.


Article last edited on: 2002-02-15 00:00:00

Rate this article

Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential