ARM Technical Support Knowledge Articles

INTERRUPTS DIALOG

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

In the uVision Debugger, when I look at the Interrupt Dialog (Peripherals - Interrupt) I see only the vectors for the base 8051 interrupts (0-4). I know that the C51 compiler supports more interrupts. The NOINTVECTOR compiler flag is not used. Why don't I see more interrupts?

ANSWER

The interrupts displayed in the Interrupt dialog show the interrupt sources for the selected device. Even though the C51 compiler supports up to 32 interrupts, not all of these are used on every 8051 derivative. The interrupts that are available depend on the chip you use. Make sure your chip supports the specific interrupt your are looking for.

SEE ALSO

Article last edited on: 2004-06-29 15:39:52

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential