ARM Technical Support Knowledge Articles

APPLICATION ERROR WHEN CONVERTING LEGACY CODE

Applies to: A51 Macro Assembler

Answer


Information in this article applies to:


QUESTION

I am converting legacy assembly code from an Archimedes assembler to the Keil A51 assembler. When I compile the code in a DOS window, I get an A51.EXE Application Error at location 0x0CDE. What is wrong?

ANSWER

You should read and apply the Keil Knowledgebase article on converting Legacy assembler code to the Keil A51 assembler. Also check all the Assembler Directives to make sure that they are correct for the Keil A51 assembler. An incorrect directive like $NOCOND or $XR may cause this error to appear when running in a DOS window.

MORE INFORMATION

SEE ALSO

Article last edited on: 2007-03-27 17:33:47

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential