ARM Technical Support Knowledge Articles

ADDING THIRD PARTY DLL SUPPORT IN TOOLS.INI

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I want to add support for the Cygnal 8051F JTAG debugger. I see all the other chip debugger DLL's in the KeilC51BIN subdirectory. I put my Cygnal debugger in the BIN directory but can not get it to run. What am I doing wrong?

ANSWER

The Cygnal DLL must be added to the TOOLS.INI file found in the KEIL folder. To add third-party or custom debugger DLL support to this file you must:

  1. Add the DLL to the KEILC51BIN subdirectory.
  2. Add the driver to the TOOLS.INI file. Locate the [C51] section and add the Cygnal driver to the list. For example:
    TDRV0=BINMON51.DLL ("Keil Monitor-51 Driver")
    TDRV1=BINISD51.DLL ("Keil ISD51 In-System Debugger")
    TDRV2=BINCYGC8051F.DLL ("Cygnal 8051F Driver")
    

MORE INFORMATION

SEE ALSO

Article last edited on: 2005-07-27 08:30:11

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential