ARM Technical Support Knowledge Articles

KEIL MON51 CONFIGURATIONS FOR EZUSB FX

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

Do I have to configure the Keil Monitor 51 for the Cypress EZ-USB parts or are there preconfigured monitors available?

ANSWER

The following uVision compatible monitors are preconfigured for the Cypress parts and are found in the default Cypress subdirectory C:\Cypress\USB\Target\Monitor. They are loaded into the target (EZ-Link) board and serve as an interface to the Keil debugger so you may view target memory, step through code, set breakpoints, etc. These 4 monitors are the only ones available. Due the complexity of the Cypress, custom monitors cannot be created.

NOTE:

None of the above monitors were designed to work with code-banked applications.

Other monitor configurations have been tested by Cypress and are available from Cypress support.

MORE INFORMATION

SEE ALSO

Article last edited on: 2011-05-09 06:51:23

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential