ARM Technical Support Knowledge Articles

USING SERIAL PORT 1 WITH THE MSC1210

Applies to: ISD51 In-System Debugger

Answer


Information in this article applies to:


QUESTION

I'm working with ISD51 and the TI MSC1210 chip. ISD51 is written to work via Serial Port 0. However, my application also uses Serial Port 0. Consequently, ISD51 won't work.

Is there any way to configure ISD51 to use Serial Port 1 of the TI MSC1210?

ANSWER

Yes. An updated revision of ISD51 supports Serial Port 1 using interrupt vector 3Bh.

RESOLUTION

This is corrected in the C51 V7.02 (and later) update. You may download the latest updates from the Keil Website.

SEE ALSO

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2005-05-25 09:21:02

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential