ARM Technical Support Knowledge Articles

OCDS DEBUGGER WITH USER APPLICATION IN ROM

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I'm currently using an Infineon 165UTAH board and debugging my application in RAM using OCDS as described in Application Note 146. Now I would like to store my application in ROM (in FLASH memory to be exact) and still use the ODCS debugger. How do I use the OCDS debugger with my application stored in ROM?

ANSWER

An example application that is configured for OCDS debugging with the Infineon EASY UTAH board is available in the folder: ..\C166\Examples\Boards\Infineon EASY UTAH. Basically, it is important that the BUSCON / ADDRSEL / SYSCON configuration settings under Project - Debug - Driver Settings match with your target hardware. This topic is covered in the OCDS User's Guide. Refer to C16xU and C165UTAH Devices.

MORE INFORMATION

SEE ALSO

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2009-01-08 06:45:45

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential