ARM Technical Support Knowledge Articles

DS80C400 CONTIGUOUS MODE DOES NOT WORK

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I have a program that works perfectly with Dallas DS390 in contiguous mode. When I change the target chip to Dallas DS80C400, keeping the same settings, the program should still work since DS390 and DS400 are comparable, but the contiguous mode is not working properly over DS400. What could be wrong?

ANSWER

This is a device database problem that has been resolved in C51 Version 7.04. You may download the latest updates from the Keil Website.

SEE ALSO

ATTACHED FILES

Request the files attached to this knowledgebase article.

Article last edited on: 2005-08-04 07:27:44

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential