ARM Technical Support Knowledge Articles

PROBLEMS WITH THE INFINEON EASY UTAH BOARD

Applies to: MON166 Target Monitor

Answer


Information in this article applies to:


QUESTION

I have the Infineon EASY UTAH Board for the C161U or C165UTAH and I'm trying to use the Keil Monitor-166 together with the uVision Debugger for serial debugging through the ASC0 port. So far, I can't get the monitor to work. What is wrong?

ANSWER

The Infineon EASY UTAH Board has additional non-standard lines on the UART connector. You need a modified Monitor DLL that sets the correct levels on this UART connector.

You must copy the modified DLL to the KeilC166Monitor folder.

As an alternative you may consider OCDS Debugging using Keil ULINK.

Article last edited on: 2005-05-28 22:51:48

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential