|ARM Technical Support Knowledge Articles|
Applies to: MCB900 Evaluation Board
Information in this article applies to:
I'm using the MCB900 Board and I have problems programming P89LPC932 devices. I know that there are different device steppings available. Can you give me information on how to program these devices with the MCB900 Board?
Currently there are two MCB900 board variants and two P89LPC932 device versions available on the market. The following gives you a brief overview.
To program F-Step devices, modify the board as follows:
Then, insert the jumper into RESET for programming and use Flash Magic version 1.71 or later (http://www.esacademy.com/software/flashmagic). In FlashMagic, enable Use DTR and RTS to enter ISP mode under Options -> Advanced Options -> Hardware Config.
Article last edited on: 2006-11-18 08:39:01
Did you find this article helpful? Yes No
How can we improve this article?