ARM Technical Support Knowledge Articles

MISSING PARTS (J2,R7,R8) ON THE BOARD

Applies to: MCB900 Evaluation Board

Answer


Information in this article applies to:


QUESTION

I have the MCB900 board Version 2, but the parts J2, R7, and R8 are empty. Do I need to add these parts before using the board? Why are these parts missing?

ANSWER

The MCB900 board uses the P89LPC932 E-step or F-step devices that have an enhanced flash ISP loader. This loader does not require extra jumpers or extra off-chip resistors. By omitting the jumper J2 and the resistors R7 and R8, you have an extra I/O pin available.

MORE INFORMATION

SEE ALSO

Article last edited on: 2006-11-30 12:26:31

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential