ARM Technical Support Knowledge Articles

SAVE / RESTORE CODE COVERAGE INFORMATION

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I need to validate a complex Smart Card Operating System. For software certification, I need a report showing that all paths in my program are fully executed. The nature of my system requires that I restart the debugger several times. Is there a way to save and restore code coverage information so that I can merge the results of several test sessions?

ANSWER

Yes. The uVision Debugger COVERAGE command has the additional options SAVE and RESTORE. These allow you to save the current code coverage status and restore this information in another debug session. For example:

SEE ALSO

Article last edited on: 2007-02-27 11:06:53

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential