ARM Technical Support Knowledge Articles

LOAD EXISTING PROJECTS

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I have an existing project along with an absolute object file. This project was created with uVision1 and debugged with dScope.

I would like to test this now with the updated uVision, but I do not want to generate a complete project for it. Is there a fast way to load the already built project into the uVision Debugger and what are the steps to do this?

ANSWER

Yes, there is a simple way. Just perform the steps described below.

  1. Create a new folder and copy the file that you want to load to this folder.
  2. Start µVision and use Project -> New Project... to create a new project file in the folder. As guideline, you should use the base name of the absolute object or HEX file as project file name (i.e. TEST.UV2).
  3. Select the device that you are using from the Device Database.
  4. Open the dialog Project -> Options for Target -> Output and enter the filename under Name of Executeable that you want to load. You can even use the name of an Intel HEX file here. By default, µVsion already enters the project name without extension.

Now start debugging with Debug -> Start/Stop Debug Session.

MORE INFORMATION

Article last edited on: 2005-07-22 16:46:50

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential