ARM Technical Support Knowledge Articles

CAN'T EXECUTE C51.EXE, C251.EXE, OR C166.EXE

Applies to: uVision IDE

Answer


Information in this article applies to:


SYMPTOM

When using 'Translate file', 'Build target' or 'Rebuild all target files', uVision reports the following error:

--- Error: can't execute 'C:KeilC166BINC166.EXE' (or C51.EXE or C251.EXE)

The C source file is on a Novell network drive and the filename is longer than 8 characters.

CAUSE

This problem appears to be caused by the Novell Client Version 4.83.

RESOLUTION

Install Service Pack 2 or later of the Novell Client.

Article last edited on: 2004-06-15 13:39:58

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential