ARM Technical Support Knowledge Articles

HOW TO AVOID STEPPING INTO INTERRUPTS

Applies to: ULINK USB-JTAG Debugger

Answer


Information in this article applies to:


QUESTION

I have a program that implements a timer interrupt which runs in the background. When I single-step through my program, the ULINK USB-JTAG Debugger steps into the interrupt service routine. How do I disable this so that I can just single-step through my program?

ANSWER

This was a problem of the BETA release that has been corrected. Now, ULINK correctly single-steps in your code.

Article last edited on: 2007-01-28 19:10:13

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential