ARM Technical Support Knowledge Articles

FLASHMON CRASHES WHILE LOADING ON ATMEL DEVICE

Applies to: FlashMON Flash Memory Target Monitor

Answer


Information in this article applies to:


QUESTION

I am using FlashMon on my T89C51CC01. Although I installed the Monitor on my CC01 as documented, it reports

CONNECTION TO TARGET SYSTEM LOST

when I try to load my program.

ANSWER

The bootloader installed in the controller is too old. Install the UART Bootloader V1.4.0 (or greater) available at: www.atmel.com

This requires a parallel programmer and cannot be done via ISP(FLIP).

MORE INFORMATION

SEE ALSO

Article last edited on: 2005-02-14 18:23:53

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential