ARM Technical Support Knowledge Articles

COMPILER GENERATES ZERO LENGTH JUMP

Applies to: C51 C Compiler

Answer


Information in this article applies to:


QUESTION

When I compile a C file to a .src, then to .obj, some instructions that should jump over the next instruction end up simply jumping to the current location. Essentially not jumping anywhere at all.

How can I make the compiler jump to the proper location?

ANSWER

This is a problem with early revisions of the Version 7.06 compiler that is corrected in the C51 Version 7.07 update.

Article last edited on: 2005-05-20 09:36:28

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential