ARM Technical Support Knowledge Articles

ACCESS BREAKPOINTS ON CYGNAL HARDWARE

Applies to: uVision Debugger

Answer


Information in this article applies to:


SYMPTOM

I'm trying to set an access breakpoint on my Cygnal target hardware, using the Cygnal JTAG adapter. uVision responds:

Error 73: unsupported breakpoint type

CAUSE

The Cygnal serial/JTAG adapter, and associated driver DLL, only allows the use of hardware breakpoints. This means that the only breakpoints that can be set are on execution.

RESOLUTION

Unfortunately, access breakpoints cannot be used with the Cygnal serial/JTAG adapter.

MORE INFORMATION

Article last edited on: 2004-05-01 13:44:43

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential