ARM Technical Support Knowledge Articles

PROGRAMMING FLASH ON MCB21XX BOARDS

Applies to: General Topics

Answer


Information in this article applies to:


QUESTION

How do I download a hex file to the MCB2100 evaluation board?

ANSWER

Follow the instructions in the appropriate MCB21xx Board Manual. Pay careful attention to the 'Using the LPC2000 Flash Utility' section.

You also need the latest version of the LPC2100 Flash ISP Utility available for download from Philips.

Make sure that the settings in the LPC2100 Flash ISP Utility match those shown in the board manual. There was an error in the illustration. The XTAL Freq (in kHz) should be 12000, not 60.

If you are still having problems connecting to the board after following the instructions in the manual, here are some more things to try:

MORE INFORMATION

SEE ALSO

Article last edited on: 2006-10-29 19:07:42

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential