ARM Technical Support Knowledge Articles

CAN'T DEBUG CHIPCON DEVICES

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I'm using a ChipCon CC1010 Development Kit. The debugger stopped communicating after I upgraded the evaluation version of uVision to a full version. How do I fix this?

ANSWER

The ChipCon CC1010 requires a special debug driver. The reference to it was lost when the full version installed. To restore the reference to the ChipCon CC1010 In-System Debugger driver, re-install the ChipCon CC1010IDE software. Then re-select Chipcon CC1010 In-System Debugger driver in Options for Target — Debug Tab — Use: section in your project.

Article last edited on: 2007-02-01 11:22:11

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential