ARM Technical Support Knowledge Articles

PROBLEM WITH INITIALIZED VARIABLES ON ADUC7000

Applies to: GNU C Compiler for ARM

Answer


Information in this article applies to:


QUESTION

I have started using the Analog Devices ADuC7000 Quick Start Development Kit. Everything worked fine until I started using variables that are initialized at the file level. There seem to be two problems:

  1. When I use ULINK for Flash programming, I receive the following error:
    Error: No Algorithm found for Address 0x00010000
    
  2. When I use the simulator to debug the program the variables have incorrect values.

ANSWER

The configuration for the ADuC7000 that is part of DK-ARM version 1.3 has these problems. Download the configuration files in the Attached Files below and use them in your project.

MORE INFORMATION

SEE ALSO

Article last edited on: 2006-07-10 18:33:28

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential