ARM Technical Support Knowledge Articles

HALT BUTTON DOES NOT STOP SIMULATOR EXECUTION

Applies to: C166 C Compiler

Answer


Information in this article applies to:


SYMPTOM

While debugging using the simulator, the Halt button does not always work after executing the SIGNAL KILL command.

CAUSE

This may happen with earlier µVision 3.04 versions while displaying these signals with the built-in Logic Analyzer.

RESOLUTION

This problem is corrected in the C166 V4.23d (and later). You may download the latest updates from the Keil Website.

Article last edited on: 2005-05-20 10:52:00

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential