ARM Technical Support Knowledge Articles

EPM900 NOT RESPONDING AFTER ISP PROGRAMMING

Applies to: EPM900 LPC Emulator

Answer


Information in this article applies to:


QUESTION

I have been using my EPM900 emulation board In-System Programming ability. Recently, the board has stopped responding. What is wrong?

ANSWER

You should contact Philips to get programmed LPC935 bond out chips. The design of the LPC932 bond out chip makes it possible to damage the chip during ISP programming. The LPC935 bond out chips are protected in a way that prevents them from being damaged from ISP programming.

MORE INFORMATION

SEE ALSO

****************************************************************************

Article last edited on: 2006-11-30 11:06:30

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential