ARM Technical Support Knowledge Articles

HOW TO SET THE ULINK VCC JUMPER

Answer


Information in this article applies to:


QUESTION

What does the VCC jumper on the ULINK USB-JTAG adapter board do?

ANSWER

JTAG requires a VCC power source. This jumper tells the ULINK board where the VCC power for the JTAG connector comes from. If the target development board provides this power, the jumper should be in the VCC to Ext. position. If the ULINK board is to provide VCC power for JTAG, the jumper should be in the VCC to 3.3V position.

MORE INFORMATION

Article last edited on: 2009-04-09 11:55:43

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential