ARM Technical Support Knowledge Articles

PROJECT BUILD STOPS UNEXPECTEDLY AT PL/M MODULE

Applies to: uVision IDE

Answer


Information in this article applies to:


QUESTION

When I select Build target or Rebuild all target files in uVision the build process always stops at one of my PL/M-51 source files. In the Output Window I see that this file compiles with 0 errors. The last line shows Target not created. How can I solve this problem?

ANSWER

The PL/M-51 compiler probably generates warnings during the compilation. Unfortunately, only error messages are visible in the uVision Output Window. Warnings are not displayed there but they stop the build process.

You should either fix the warnings in your source code or you can tell uVision to stop the build process only on errors. To do this, open the Options for File dialog and select Translator Errors (Exit Code >= 2) under Stop on Exit Code.

SEE ALSO

****************************************************************************

Article last edited on: 2005-01-13 09:39:04

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential