CHANGE CAN INTERFACE ON XC16X DEVICES
Applies to: C166 C Compiler
Answer
Information in this article applies to:
- C166 Version 5
- MCBXC167 Evaluation Board
QUESTION
I have an application that is using the CAN interface on the Infineon XC16x Evaluation Board. Now I want to run it on the Keil MCBXC167 Board. The Infineon board uses different I/O pins for the CAN interface. What do I need to change to use the Keil MCBXC167 Board?
ANSWER
Basically you must change the settings of the following SFR registers: ALTSELP4, PISEL and DP4. After this modification the software should run correctly.
You may also use Infineon DAvE to setup an project using the correct CAN pin assignments and copy these configuration to your software.
MORE INFORMATION
- Infineon XC16x User's Manual
- Application Note 181: CAN Programming and Simulation on the MCB-XC167
- Application Note 182: Using Infineon DAvE and Keil C166 / µVision3
- Refer to CAN Interface in the MCBXC167 User's Guide.
SEE ALSO
Article last edited on: 2006-11-30 12:50:47
Rate this article
![[Bad]](images/fb_cross.png)
![[Good]](images/fb_tick.png)
Disagree? Move your mouse over the bar and click
Did you find this article helpful? Yes No
How can we improve this article?
