ARM Technical Support Knowledge Articles

CRASHES AFTER MONITOR IS REBUILT

Applies to: MON166 Target Monitor

Answer


Information in this article applies to:


SYMPTOM

When making changes to a Monitor-166 configuration, rebuilding the firmware project causes the monitor to fail. The specific symptoms of this are that the monitor crashes while it is downloaded to the target system. Everything works fine when using the pre-built monitor from the release files or using an older version (5.03).

CAUSE

In C166 Version 5.04 and 5.05, the MON.LIB file was modified to support new L166 Linker options. This file is required to rebuild the monitor. Unfortunately, the modified library was excluded from the actual release.

RESOLUTION

Use the MON.LIB that is available as an attachment to this Knowledgebase Article.

STATUS

This library will be included in subsequent releases.

Article last edited on: 2005-07-01 17:48:04

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential