ARM Technical Support Knowledge Articles

SIMULATION CANNOT BE STOPPED ON TOSHIBA LAPTOP

Applies to: uVision Debugger

Answer


Information in this article applies to:


QUESTION

I am using µVision3 on my Toshiba Tecra S1 notebook. The simulation starts immediately with execution after I enter the debugger. I cannot stop the execution. Sometimes when the stop button is active in the toolbar, the debugger starts running unpredictably. Is this a threading problem?

ANSWER

No, this is not problem caused by the µVision3 IDE. Toshiba installs a set of utilities on the Tecra series, which helps to manage the special keys on the laptop. One of these utilities can generate keyboard input events to the active application.

RESOLUTION

Remove some shortcut key definitions from µVision3:

Alternatively, you may redefine these entries with different shortcut key definitions.

Article last edited on: 2007-01-11 15:07:48

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential