SUPPORT FOR SEGGER J-LINK
Applies to: uVision Debugger
Answer
Information in this article applies to:
- uVision Version 3.20a
QUESTION
Does the uVision Debugger work with the Segger JLINK or other RDI debuggers?
ANSWER
Yes. Starting with uVision V3.20a, the Segger JLINK is supported via RDI.
Starting with MDK-ARM version 3.50 and later, support was added for the SEGGER Microcontroller J-Link and J-Trace hardware debug units. The recommended debugging solution is using the Keil-provided J-link drivers - not the RDI interface.
MORE INFORMATION
- Refer to the Release Notes for CARM V2.32a.
- Refer to the J-Link/J-Trace User's Guide.
SEE ALSO
- UVISION DEBUGGER: ATMEL SAM-ICE SUPPORT
- UVISION DEBUGGER: USING SAM-ICE WITH UVISION
- UVISION DEBUGGER: SUPPORT FOR J-LINK
Article last edited on: 2012-01-31 05:38:51
Rate this article
![[Bad]](images/fb_cross.png)
![[Good]](images/fb_tick.png)
Disagree? Move your mouse over the bar and click
Did you find this article helpful? Yes No
How can we improve this article?
