ARM Technical Support Knowledge Articles

DEBUGGING OF AT91C51RB2

Applies to: FlashMON Flash Memory Target Monitor

Answer


Information in this article applies to:


QUESTION

Is there a pre-configured FlashMon Version for the AT89C51RB2?

ANSWER

No, we do not provide a pre-configured version for this downgrade device. You may create your own configuration,  but we recommend using a superset device (for example the AT89C51RD2) for debugging. The advantage of the superset device is that you do not run out of memory during debugging, since the Flash Monitor requires a certain amount of memory.

Refer to the file ..c51FlashMonReadMe.txt for a complete list of pre-configured Monitor versions.

MORE INFORMATION

Article last edited on: 2007-01-09 15:27:58

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential