ARM Technical Support Knowledge Articles

CODE LOAD VERY SLOW

Applies to: ULINK USB-JTAG Debugger

Answer


Information in this article applies to:


QUESTION

When I load code via ULINK (without Flash programming), the load takes an extremely long time, in my case about 5 minutes for a 300K file.

What can be wrong here?

ANSWER

ULINK performs the following when you start the debug session:

Therefore, to speed up application download, you should disable both options. However, at the same time, you should also enable all Cache Options so that ULINK remembers the memory content that has been already read.

MORE INFORMATION

SEE ALSO

Article last edited on: 2007-01-28 19:21:39

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential