ARM Technical Support Knowledge Articles

CANNOT DEBUG ON LUMINARY LM3S811-EV BOARD

Applies to: uVision Debugger

Answer


Information in this article applies to:


SYMPTOM

Whenever I try to debug a program on the Luminary LM3S811-EV demo board, uVision3 locks up, and I need to kill and restart it, to get it to respond again.

CAUSE

There was an issue with certain versions of the ARM debugger, that caused the uVision3 IDE to become unresponsive.

RESOLUTION

Download the attached file.

Unzip it into C:KeilARMBIN, replacing the old version, already there.

STATUS

fixed in update

Article last edited on: 2007-01-30 09:54:30

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential