ARM Technical Support Knowledge Articles

ULINK2 ADAPTER NOT RECOGNIZED

Applies to: ULINK USB-JTAG Debugger

Answer


Information in this article applies to:


QUESTION

I just purchased a ULINK2 adapter but it doesn't communicate with my target board. I tried an older ULINK adapter and it works OK. Is there something wrong with my ULINK2 adapter?

ANSWER

You have an old version of software that does not support ULINK2. You must have the following software installed (or later) to use the ULINK2 adapter:

MORE INFORMATION

SEE ALSO

Article last edited on: 2007-02-01 16:53:23

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential