ARM Technical Support Knowledge Articles

USB EXAMPLES DO NOT WORK

Applies to: MCB2300 Evaluation Board

Answer


Information in this article applies to:


QUESTION

I have downloaded the following USB example projects:

However none of these examples seems to work. I am using the MCB2370 Board. Are these examples only for the MCB2360 Board?

ANSWER

The examples work on both board variants MCB2360 and MCB2370. The problem might be the jumper settings. When the jumper J13 - ETM is set the jumper J5 - UMODE needs to be in position towards the prototyping area.

MORE INFORMATION

Article last edited on: 2007-03-01 00:51:18

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential