ARM Technical Support Knowledge Articles

ETM CONNECTOR PROBLEM

Applies to: MCBSTR9 Evaluation Board

Answer


Information in this article applies to:


QUESTION

The ETM connector on MCBSTR9 does not work on board revisions before Vers 3 since it appears that the ETM pins are mirrored.

ANSWER

This is a known issue older MCBSTR9 Boards. MCBSTR9 Vers. 4 has a correct layout for the ETM connector.

SEE ALSO

Article last edited on: 2007-07-24 10:41:25

Rate this article

[Bad]
|
|
[Good]
Disagree? Move your mouse over the bar and click

Did you find this article helpful? Yes No

How can we improve this article?

Link to this article
Copyright © 2011 ARM Limited. All rights reserved. External (Open), Non-Confidential